How fast does the NBEE or NBEE H print?

How fast does the NBEE or NBEE H print?

This article applies to FAQ
  1. The short answer is that it depends on the printing height, resin type, and layer thickness of the model. Parts printed with thinner layers capture finer detail but take longer to print.
  1. As the world fastest printer so far, NBEE and NBEE H can print 6 full arches in 5 minutes.
  1. Fill the build volume of the NBEE (192× 120× 180 mm) and the NBEE H (192× 120× 380 mm) to maximize efficiency and print multiple copies of a model at the same time.
  1. Open a model in UNIZ Dental to check and calculate the estimated print volume and print time.

    • Related Articles

    • Printing Tips & Cautions

      This article applies to NBEE, NBEE H, NBEE D Why are these considerations so important? Ensuring proper printing precautions is essential for achieving successful prints and maintaining the longevity of your 3D printer. These precautions help prevent ...

    • Printing failure case sharing——printed model is cracked

      Symptoms The printed model contains cracks. cracked model cracked model cracked model Possible Causes The temperature of the resin is insufficient The printer placement is unstable Exposure time is insufficient Not enough time for liquid resin ...

    • Motor control for NBEE or NBEE H

      This article applys to Uniz NBEE and NBEE H 3D Printer If you want to check whether the motor works normally or want to move the position of the Build Platform, it is recommended to use the motor control  function as following. ...

    • Printing issue-Elephant's Foot

      What is Elephant's Foot? Elephant's Foot is a common phenomenon in bottom-up light-cured 3D printers, referring to a protrusion that occurs near the base of the model. Causes Prolonged exposure and curing of the first layer or initial layers Based on ...

    • Printing failure case sharing——supports fracture

      Symptoms The model supports are broken, unable to connect to the model. Possible Causes The touch point size of supports is too small The diameter of supports is too small The spacing of supports is too big Exposure time is insufficient Moter speed ...