How to replace HDMI board for NBEE?

How to replace HDMI board for NBEE?

Preparation

  1. Socket Wrench;
  2. A new HDMI board.

Step1: Remove the faulty HDMI board 

  1. Power off the printer;
  2. Remove the front casing and put it aside, be careful of the connected cables;


  3. Unscrew the 3 nuts on the HDMI board；


  4. Remove the HDMI board from the fixed column;


  5. Unplug the screen cable, power cable and HDMI signal cable.




Step2: Install the new HDMI board

  1. Plug the screen cable,HDMI signal cable and power cable back into the new HDMI board;


  2. Tighten the 3 nuts and secure the HDMI board;
  3. The installation is complete.

Conclusion

After installation, please check the status of the indicator lights on the HDMI board.If the red light on the HDMI is always on, it means the wiring is normal. If the red light flashes or does not light up, check whether the wiring on the HDMI board and the motherboard is loose.It is also recommended to perform an LCD test to verify the successful installation of HDMI board. 

    • Related Articles

    • How to replace the mainboard

      This article applies to NBEE, NBEE J, NBEE D, and NBEE H printer. Before replacement Items to prepare: ①New mainboard;②Hexagon Wrench M3. Report SN to UNIZ support: How to get SN. Please ignore if it has been sent to UNIZ support team ...

    • How to replace the screen cable

      This article applies to NBEE , NBEE D , NBEE H. Description The LCD screen cable refers to the cable that connects the liquid crystal display screen (LCD screen) to the main control board (HDMI board). This cable usually is responsible for ...

    • How to drain coolant from NBEE

      When does coolant need to be drained When the coolant becomes murky and no longer transparent, it is necessary to drain the old coolant, clean the cooling system and fill in new coolant； When the cooling board is cracked or crushed, necessitating ...

    • What is the build volume of the NBEE & NBEE H?

      This article applies to FAQ The build volume of the NBEE is 19.2× 12× 18 cm (7.5 × 4.7 × 7.1 in). The NBEE H uses the same build platform, but can lift it slightly higher, for a build volume of 19.2× 12× 38 cm (7.5 × 4.7 × 15 in). For full details, ...

    • The LCD screen illuminates but doesn't display the logo during the LCD TEST

      Symptoms When performing LCD TEST, the screen is fully bright and no UNIZ logo is displayed on the screen. Possible Causes Screen cable is loose; HDMI cable is loose; Screen cable failure; HDMI board failure; LCD screen failure. Diagnostic Steps ...