Motor control for NBEE or NBEE H

Motor control

This article applys to NBEE, NBEE D, NBEE H.


Introduction to the function:

The Motor Control allows you to manually move the position of the build platform. If you want to check the functionality of the motor that controls the build platform, it is recommended to use the function.

How to use the function:

1. Enter Tools, Motor Control.

2. Select the distance you want to move the platform. Then press the up arrow, and the platform will move.


Note: The platform movement needs time, please do not press the arrow frequently.

    • Related Articles

    • What is the build volume of the NBEE & NBEE H?

      This article applies to FAQ The build volume of the NBEE is 19.2× 12× 18 cm (7.5 × 4.7 × 7.1 in). The NBEE H uses the same build platform, but can lift it slightly higher, for a build volume of 19.2× 12× 38 cm (7.5 × 4.7 × 15 in). For full details, ...

    • How fast does the NBEE or NBEE H print?

      This article applies to FAQ The short answer is that it depends on the printing height, resin type, and layer thickness of the model. Parts printed with thinner layers capture finer detail but take longer to print. As the world fastest printer so ...

    • What is the difference between the NBEE and the NBEE H?

      Mian difference: NBEE NBEE H Molding volume 192 x 120 x 180 mm 192 x 120 x 380 mm Software UNIZ Dental UNIZ Industry Application fields Dentistry, jewelry Industry The NBEE and NBEE H use the same Low Force Stereolithography (LFS) technology to ...

    • How to drain coolant from NBEE

      When does coolant need to be drained When the coolant becomes murky and no longer transparent, it is necessary to drain the old coolant, clean the cooling system and fill in new coolant； When the cooling board is cracked or crushed, necessitating ...

    • NBEE build platform cannot lift up during printing while printing process continues

      This article applies to NBEE, NBEE D, NBEE J, NBEE H. Symptoms After starting the print, the build platform can move down until into the resin tank, but after few seconds of curing, when it tries to lift up, the motor trips (you can hear the sound of ...