NBEE-Ambient Light Brightness Setting Process-EN

NBEE-Ambient Light Brightness Setting Process-EN



NBEE Printer Atmosphere Lamp—Brightness Setting Process
*For NBEE Printer Only

1. Enter the Factory Interface

After booting, you can see the Standby interface of the touch screen. 
  1. Go click the green origin in the upper left corner (shown in the red frame) five times in a row to enter the factory interface.
  1. You can press RETURN to go back.

Attention: The factory interface of the NBEE printer is used for related settings and testing in the printer production process, and is generally not open to end users, please pay attention.


2. Brightness Setting

2.1 Click "AMBIENT LIGHT" to enter the ambient light brightness adjustment interface.



2.2 In the figure below, the setting box corresponding to "OBSERVATION LIGHT" is used to set the brightness of the ambient light; the setting box corresponding to "LIGHT STRIP" is used to set the brightness of the headlight strip. The setting range is: 0~100. The user can set the appropriate brightness value according to the experience, and then click "SETTING" to complete the calibration.

Note: Both lights are turned on when powered on and off when powered off, and their switches cannot be controlled.


    • Related Articles

    • Factory Interface Operation Process-NBEE-EN

      Factory Mode Interface Operation Process *For NBEE Printer Only Operation process: Noted: This process is used for the factory operator to inspect each printer’s functionality at final step of finished products inspection, like light intensity ...

    • NBEE LED light does not light up when printing

      Symptom When printing, the LCD screen is completely dark and no light is emitted from the LED light board. Possible Causes After replacing the mainboard, the light intensity value is not written； Loose wiring between LED driver board and mainboard； ...

    • Network Settings for NBEE

      Network Settings 1. LAN You could connect the printer with your router via Ethernet cable. Go the SETTINGS menu. Click LAN button. Set to AUTO mode on. The printer will get IP address automatically. Click CONNECT. If you set AUTO mode off, you need ...

    • Dimming of the LCD screen

      This article applies to NBEE, NBEE H, NBEE J, NBEE D. Symptom When doing LCD test and exposure cleaning, it can be obviously seen that the brightness of the LCD screen has become dim. Possible Causes LED board failure; LED driver board failure; ...

    • NBEE build platform out of step

      Symptoms The build platform vibrates slightly when it moves to the bottom. The printing process can start, but the screen will not light up and the printing process cannot be continued. Possible Causes The limit switch is faulty and cannot be ...