Receiving and Unboxing your NBEE

Receiving and Unboxing your NBEE

OPEN IT UP

① Remove the four handle locks around the bottom of the box.

② Use the holders to lift the upper box up, and leave it to the side.

REMOVE THE FOAM PACKAGING

③ Remove front and rear foam.

④ Remove top foam.

TAKE THE PRINTER OUT

⑤ Remove the plastic wrap, then flip out the two handles on the sides of the printer.

⑥ Hold both handles and lift the printer out of the bottom foam, leave it aside and flip the handles back.



GET THE ACCESSORIES

①   Remove the four screws on the back of the printer and the bottom rear cover plate.

②   Remove the packing strap.

③   Take out the accessory box, resin box, and Build Platform box.


Note that packing list would differ sometimes when it comes to different batch of production.

④   The accessory box contains essential accessories including power cord and flash drive etc.


    • Related Articles

    • What is the build volume of the NBEE & NBEE H?

      This article applies to FAQ The build volume of the NBEE is 19.2× 12× 18 cm (7.5 × 4.7 × 7.1 in). The NBEE H uses the same build platform, but can lift it slightly higher, for a build volume of 19.2× 12× 38 cm (7.5 × 4.7 × 15 in). For full details, ...

    • Screw Positions on NBEE casing

      This article applies to NBEE, NBEE H, NBEE J. Why do you need to know the screw positions on NBEE casings? After disassembling and repairing the printer, you need to install the NBEE casing back to protect the internal structure. Through this ...

    • How fast does the NBEE or NBEE H print?

      This article applies to FAQ The short answer is that it depends on the printing height, resin type, and layer thickness of the model. Parts printed with thinner layers capture finer detail but take longer to print. As the world fastest printer so ...

    • NBEE build platform out of step

      Symptoms The build platform vibrates slightly when it moves to the bottom. The printing process can start, but the screen will not light up and the printing process cannot be continued. Possible Causes The limit switch is faulty and cannot be ...

    • How to replenish coolant in NBEE

      Preparation before operation Prepare items: ①M4 hexagonal wrench ②UNIZ brand coolant ③Nitrile gloves Operation steps Turn off the printer and unplug the power cord; Remove the rear casing of the printer; There are wires connected to the rear casing. ...