Resin Storage

Resin Storage

Used resin

  1. After the model is printed, it is recommended that the storage time of resin in the resin tank should not exceed 12 hours.
  2. In order to obtain better printing effect, please recover the remaining resin into the resin bottle in time and shake it well when it is used again.

Unused resin

  1. Store resin away from direct sunlight, in a well-ventilated area.
  2. Close the cartridge vent cap to prevent leaks.
  3. Shake resin bottles at least every two weeks to keep resin thoroughly mixed.
  4. Regularly check the area where bottles are stored for leaks and spills. Clean up spilled resin with soap and water.




    • Related Articles

    • Disposing of Resin

      Disposing of Resin Liquid resin Dispose of resin when it has become too contaminated to be filtered, has reached the end of its lifetime, or has otherwise been made unsuitable for use. Disposal with a chemical waste stream To dispose of liquid resin ...
    • Resin Filtration

      Why need to do resin filtration After a print failure, there are cured layers and/or particles left in the resin tank, and it's difficult to clean up. Resin filtration is needed to remove contamination and residues to protect the LCD screen from ...
    • Advanced support removal techniques

      Advanced support removal techniques This article applies to Finishing, SLASH 2 PLUS, SLASH 2H PLUS, NBEE, NBEE H Supports are often necessary for successful LCD printing, which makes support removal an essential step in post-processing printed parts. ...