Safety

Safety with UNIZ 3D Printers-NBEE

This article applies to SLASH 2 PLUS , NBEE

UNIZ 3D printers are precision tools that require respect and care to ensure safe operation. Follow all safety considerations listed here during operation.

Throughout the manual and other documentation, safety notices are marked with standard words and symbols. Read the definitions below to understand these markings and how they relate to your safety.


SYMBOL

MEANING

DANGER indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.

WARNING indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury.

CAUTION indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury.

NOTICE indicates information considered important, but not hazard-related. Not following this information could void the warranty or result in damage to the machine.



DANGER: Ethylene glycol is a flammable chemical.



WARNING: The light source may be harmful to the eyes. Try to avoid looking directly.

    • Related Articles

    • How to remove air bubbles in the liquid cooling panel of NBEE

      Symptoms When the LCD screen is on, there are air bubbles in the liquid cooling board under the LCD screen. Small air bubbles Large air bubbles Possible Causes Residual air left in the coolant, and air bubbles accumulate at the liquid cooling board. ...

    • How to replenish coolant in NBEE

      Preparation before operation Prepare items: ①M4 hexagonal wrench ②UNIZ brand coolant ③Nitrile gloves Operation steps Turn off the printer and unplug the power cord; Remove the rear casing of the printer; There are wires connected to the rear casing. ...

    • How to replace the mainboard

      This article applies to NBEE, NBEE J, NBEE D, and NBEE H printer. Before replacement Items to prepare: ①New mainboard;②Hexagon Wrench M3. Report SN to UNIZ support: How to get SN. Please ignore if it has been sent to UNIZ support team ...

    • Motor control for NBEE or NBEE H

      This article applys to Uniz NBEE and NBEE H 3D Printer If you want to check whether the motor works normally or want to move the position of the Build Platform, it is recommended to use the motor control  function as following. ...

    • maintenance tips-resin tank

      This article applies to NBEE, NBEE H, NBEE D. Product Introduction Currently, UNIZ has launched two versions of resin tanks, black and silver, with the same size and NFEP single-layer film, which has the characteristics of high uniformity, strong ...