Feature introduction
New features in UNIZ Dental version 2.6.1.12
UNIZ Dental software has supported upgrading to version 2.6.1.12. This major upgrade includes five exciting and important features that will add more convenience and fun to the printing process. 1.Collision detection function This function is used to ...
Preheating
This article applies to NBEE, NBEE H, NBEE J. Function introduction: UNIZ printers are equipped with a preheating system that can heat the resin to improve its fluidity, ensuring better print results. This function is especially necessary when ...
Motor control
This article applys to NBEE, NBEE D, NBEE H. Introduction to the function: The Motor Control allows you to manually move the position of the build platform. If you want to check the functionality of the motor that controls the build platform, it is ...
Exposure Cleaning
This article applies to NBEE, NBEE H, NBEE D. Introduction to the function Exposure cleaning is a tool to facility the cleaning of the residues left in the resin tank like debris and/or cured resins. the operator to When printing fails, there may be ...
Factory Interface Operation Process-NBEE-EN
Factory Mode Interface Operation Process *For NBEE Printer Only Operation process: Noted: This process is used for the factory operator to inspect each printer’s functionality at final step of finished products inspection, like light intensity ...
NBEE-Ambient Light Brightness Setting Process-EN
NBEE Printer Atmosphere Lamp—Brightness Setting Process *For NBEE Printer Only 1. Enter the Factory Interface After booting, you can see the Standby interface of the touch screen. Go click the green origin in the upper left corner (shown in the red ...
Set Printer Nickname for NBEE
1. Go to the SETTING page and click SYSTEM button 2. Click the Printer’s name (marked in red box below) to the next step 3. Click the bar in red box marked below, and click the DEL button to delete the current nickname then input a new one. Click OK ...
Network Settings for NBEE
Network Settings 1. LAN You could connect the printer with your router via Ethernet cable. Go the SETTINGS menu. Click LAN button. Set to AUTO mode on. The printer will get IP address automatically. Click CONNECT. If you set AUTO mode off, you need ...
LCD TEST
Function introduction LCD Test is a tool designed to check the status of the LCD screen. It serves as a troubleshooting method to diagnose or identify issues related to the LCD. Operation steps 1. Remove the build platform and resin tank. 2. Enter ...